Commercial Roofing
Designed for use as an inside corner or outside corner on all TPO thermoplastic roof systems.
Features
Use: A 60mil (1.5 mm) pre-molded accessory designed for use as an inside corner or outside corner on all TPO thermoplastic roof systems. Engineered for compatibility in most corner conditions, this injection molded accessory provides several installation benefits:
Efficient welding associated with corner flashing details
Reduced inconsistencies in flashing details
Consistent final appearance of flashing details at corner conditions
Application: Cut according to the diagram below for each application. Following final flashing membrane installation, hot-air weld and hand roll in either an inside corner or outside corner condition. No additional caulking or edge sealant is required.
Material: Pre-molded, non-reinforced TPO (thermoplastic polyolefin).
Colors: White
